1/4″ Two-Position Tool Post
Cutoff Tool Rear-Mounting Block
For those who already own a standard cutoff tool holder, this spacer block will lift the cutoff tool holder the height of the blade, allowing the blade to be mounted upside down and used on the back side of the … Continued
Bump Knurl Tool Holder
2″ End Mill Holder Style Fixture
1/4″ Drill Chuck with Straight Shaft Arbor
This chuck comes with a straight shaft arbor designed to fit in our multi-tool holders with 3/8" mounting holes*. The straight shaft arbor will also work with our 3/8" insert holder tool post (P/N 7600). It has a 3/8" diameter straight shaft with a machined flat for holding in the posts. Ensure the flat surface on the arbor is oriented toward the top of the tool post, so the 10-32 x 3/4" SHC screw will be perpendicular to the flat. This orientation will assure that the arbor does not turn or move when force is exerted on the tool.
*Multi-tool holders with 3/8" holes:
3/8″ Drill Chuck with Straight Shaft Arbor
This chuck comes with a straight shaft arbor designed to fit in our multi-tool holders with 3/8" mounting holes*. The straight shaft arbor will also work with our 3/8" insert holder tool post (P/N 7600). It has a 3/8" diameter straight shaft with a machined flat for holding in the posts. Ensure the flat surface on the arbor is oriented toward the top of the tool post, so the 10-32 x 3/4" SHC screw will be perpendicular to the flat. This orientation will assure that the arbor does not turn or move when force is exerted on the tool.
*Multi-tool holders with 3/8″ holes:
Spur Driver
The spur driver is used in the headstock to drive wood when turning between centers, rather than using the 3-jaw chuck. The body has a #1 Morse taper. It has a center point and four “teeth” that bite into the … Continued
Lathe Headstock Hard Stop Kit
