This tailstock live center has a 3/8-24 adapter to hold a drill chuck. This live center is used in industrial winding operations, and has a runout of .003″.
Back to Tailstock Tools
We have temporarily stopped ALL SALES through our website, by phone or by email, of our products to allow us to catch up on our current orders. Thank you for your patience and we apologize for any inconvenience.
Image shown is a representation only. Actual product may vary.
Live Center to 3/8-24 Chuck Arbor with #0 Taper
Chuck not included
| Part No. | Description | Quantity |
|---|---|---|
| 10930 | 3/8″ bearings | 2 |
| 11824 | Shim washer | 1 |
| 11885 | 3/8-24 Chuck adapter for live tailstock body | 1 |
| 11915 | Chuck adapter live tailstock body | 1 |
Related products
1/4″ Drill Chuck with 2 Arbors
A drill chuck is probably the most important accessory you will need for your lathe. It will enable you to accurately centerline drill, ream, or tap any part mounted on the lathe. The part to be machined is chuck or collet mounted in the headstock. The tool is mounted in the tailstock chuck and fed into the part using the tailstock ram feed. Parts that are going to be mounted between centers can be center drilled this way. Other parts requiring a hole accurately drilled on-center can also be machined this way.
The Sherline tailstock chuck is a precision 3/32" (2.4 mm) to 1/4" (6.4 mm) 3-jaw chuck complete with key. The chuck is fitted with a #0 Morse arbor for use in the tailstock. Also included is a #1 Morse arbor and drawbolt so the chuck can be used in the lathe or mill headstock as well.
NOTE: If runout of less than .003″ amount is required, collets should be used to hold the drill rather than a chuck.
3/8″ Drill Chuck with Two Arbors
This chuck includes a #0 Morse arbor for use in the tailstock for center drilling and a #1 Morse arbor for use in the headstock. It will hold drills from 3/32" (2.4 mm) to 3/8" (9.5 mm) in diameter. Runout is .003" or less. If runout of less than this amount is required, collets should be used to hold the drill rather than a chuck.
NOTE: Because of its longer length and ability to hold longer 3/8" drills, this chuck is normally recommended for use on the longer 4400-series benchtop lathes.
