0
items:
$0.00
DRO Spindle Handwheel
The spindle handwheel was designed to make the task of controlling the spindle easier. With it, you can quickly stop the spindle or turn it by hand to tap a thread or inspect a part. This version has a longer … Continued
Spindle Handwheel
The spindle handwheel was designed to make the task of controlling the spindle easier. With it, you can quickly stop the spindle or turn it by hand to tap a thread or inspect a part. The handwheel mounts on the … Continued
90° 30TPI Left Hand Spiral Knurl
BRAND FORM ROLL STYLE Circular Pitch TOOTH PATTERN Left Hand TOOL MATERIAL High Speed Steel DIAMETER 1/2″ PITCH 30 WIDTH 3/16″ HOLE SIZE 3/16″ FINISH COATING Lapped Tooth Finish HARDNESS 58 to 60 RC NORMAL CIRCULAR TPI 30 WHEEL DIAMETER 3/16″ … Continued
90° 30TPI Right Hand Spiral Knurl
BRAND FORM ROLL STYLE Circular Pitch TOOTH PATTERN Right Hand TOOL MATERIAL High Speed Steel DIAMETER 1/2″ PITCH 30 WIDTH 3/16″ HOLE SIZE 3/16″ FINISH COATING Lapped Tooth Finish HARDNESS 58 to 60 RC NORMAL CIRCULAR TPI 30 WHEEL DIAMETER 3/16″ … Continued
Stepper Motor Wire Harness W/Plug
The stepper motor wire harness is 12″ long and has six wire leads pre-wired in a 5-pin connector that plugs directly into the Sherline controller box or the linear/rotary controllers.
T-Slot Cutter (Carbide, 3/8″ Shank)
T-slot nominal dimensions****Note: The T-slots are extruded into the material. Table surfaces are machined for flatness, but the slots themselves require no additional finishing processes. Slot width, top: .25″ T width, bottom: .40″ Upper slot depth: .10″ T Slot depth: … Continued
