
WW Collet Closer Base – Chucker Lathe

3C Collet Closer base – Leadscrew Lathe

3C Collet Closer base – Chucker Lathe

3C Collet Closer base – Leadscrew Lathe w/Riser

3C Headstock Hard-Stop Kit

MB Vise Fixture Hard Stop
Hard stop for the MB Vise Fixture with Talon Grips (P/N 3552-35526). What’s included in each set: One vise fixture hard stop One socket head cap screw (not shown)

MB Vise Versagrip Jaw Inserts
These inserts have two serrated sides and bite into the part surface for holding raw material. They are only compatible with the Versagrip top jaws (P/N 35535).
What's included in each set:- Four Versagrip jaw inserts
- Four socket head cap screws (not shown)

MB Vise Versagrip Top Jaws
The MB Versagrip Top Jaws are used for holding round or oddly shaped stock. These top jaws use the MB Versagrip Vise Jaw Inserts (P/N 35529) made by Mitee-Bite*. You can place the jaw inserts into any insert pockets in the MB Versagrip top jaws to accommodate differently shaped parts.
*NOTE: The MB Versagrip Vise Jaw Inserts are sold separately. What's Included:- Two Versagrip top jaws
- Four 82° screws

Pie Master Jaws
NOTE: To customers who are buying these jaws for an existing chuck, please measure the width of your current chuck jaws with a pair of mics so we can grind your master jaws to match. State your current jaw width in … Continued

Saddle Nut Oiler

Sherline 3C Collet Spindle Headstocks

Sherline 9/16″ Through-Hole Spindle Headstocks

Sherline ER-16 Spindle Headstocks

Sherline Standard Morse #1 Taper Spindle Headstocks

Pneumatic Bar Feeder

Pneumatic Bar Feeder Activation Cylinder Assembly
We’ve separated the Bar Feeder into two components to better support customers who want to build their own custom bar feeder system.
Beyond its use in a bar feeder setup, this assembly can also function as a programmable collet control for opening and closing the collet. You can use M10 and M11 G-code commands to close and open the chuck, respectively.
The Pneumatic Bar Feeder Activation Cylinder Assembly works with our machine and 3C lever collet closer to pneumatically open and close the collet. Click the “Instructions” tab above to download setup documentation.
NOTE: This system is designed for use with the MASSO Touch controller featuring the G3 board. The older G2 board is not compatible with the required MASSO relay module. If you are using a control system other than the MASSO Touch, please consult your controller manufacturer for wiring diagrams and compatibility. Most modern CNC controllers are designed to send relay signals to control external devices.

Bar Feeder Front-Mount Assembly

Accordion Way Cover Set for Ball Screw Mills

Ball Screw Coupling 8 mm – Male Mount
Ball screw coupling with an 8 mm shaft for Accu-Pro machines.