Image shown is a representation only. Actual product may vary.
About the MB Talon Grip Vise Jaw Inserts
These inserts are serrated on both sides and designed to hold raw stock. The serrated edge is part of the insert’s gripping design and strength. You can use the serrated side of these inserts to hold finished pieces without damaging the part surface if you use light clamping pressure and only if you are taking very light cuts or engraving.
What’s included in each set:
Hard stop for the MB Vise Fixture with Talon Grips (P/N 3552-35526). What’s included in each set: One vise fixture hard stop One socket head cap screw (not shown)
The Sherline MB Vise Fixture is designed to locate directly in the T-slots of our mill tables and tooling plates. By aligning the fixed and movable jaws in the T-slots, your mill table or tooling plate becomes the base for the fixture - maximizing usable table length. This setup allows you to securely hold and machine much larger or irregularly shaped parts than traditional vises can accommodate.
Workholding Versatility
The MB Vise Fixture supports a wide range of part shapes through the use of two different sets of interchangeable top jaws:
For square and rectangular stock use the standard top jaws with either:
Talon Grip Vise Jaw Inserts by Mitee-Bite
Reversible Jaw Inserts (smooth) by Saunders
For round or irregularly shaped material:
Use the MB Versagrip Top Jaws, which fit the same fixed and movable base plates. These jaws accept the MB Versagrip Vise Jaw Inserts by Mitee-Bite. The ¾" round inserts can be rotated within any insert pocket to match and grip a wide variety of part geometries securely.
Standard MB Vise Fixture Includes:
Fixed base plate
Movable base plate
Adjustable stop
3 hex keys (7/32", 5/32", 3/32")
Mounting screws and T-nuts
Insert Options:
Reversible Jaw Inserts:
Both sides are smooth for holding finished parts with minimal marking. Easily reversible in the top jaw (includes 2 inserts and 8 screws).
Talon Grip Vise Jaw Inserts:
Double-sided serrated inserts for aggressive holding of raw stock. The serrated edge enhances grip strength (includes 2 inserts and 2 screws).
MB Versagrip Vise Jaws & Inserts:
Serrated on both sides for secure gripping of raw or irregular material. Compatible only with the Versagrip jaws (includes 4 inserts and 4 screws).
MB Hard Stop:
Designed to fit in the fixed jaw insert slot and used alongside the Talon Grip Inserts for repeatable part positioning.
Notes:
Jaw inserts are sold separately. The Standard MB Vise Fixture Base Plates are required to mount any jaw inserts.
Although the serrated inserts are intended for raw stock, they may be used on finished surfaces if light clamping pressure is applied and only light machining or engraving is performed.
