Click on photo to view larger image.
The 90° angle table is a very useful work-holding fixture for milling. It can be used to hold parts on either surface. Parts can also be held from two directions at once, providing a very solid setup. Parts clamped to the vertical surface can be held perpendicular to the table even if they are not flat on the bottom. It has 3" x 3" x 3.5" work surfaces with two T-slots running full length on each. It is made from 5/8" thick extruded aluminum with the working surfaces machined flat and perpendicular. The plate has a tough, easy-to-care-for black anodized finish. Four countersunk mounting holes are provided and four 10-32 x 3/8" mounting screws and T-nuts are included. All standard Sherline clamps and accessories can be used in the T-slots for holding your work. This plate is not just for Sherline tools. It would be a handy setup fixture for mills or drill presses of any size.
A longer version of this table is available as P/N 3559. It is the same cross-section but is 10" long. Though it can only be effectively attached to the Sherline mill parallel to the mill table axis, it will hold larger parts than the 3561 version. On full-size machines, this extra length is even more of an advantage.
Return to Mill Accessories Section