BRAND | FORM ROLL |
STYLE | Circular Pitch |
TOOTH PATTERN | Right Hand |
TOOL MATERIAL | High Speed Steel |
DIAMETER | 1/2″ |
PITCH | 50 |
WIDTH | 3/16″ |
HOLE SIZE | 3/16″ |
FINISH COATING | Lapped Tooth Finish |
HARDNESS | 58 to 60 RC |
NORMAL CIRCULAR TPI | 50 |
WHEEL DIAMETER | 3/16″ |
SERIES | EP |

Related products


70° 50TPI Straight Knurl Pair
BRAND FORM ROLL STYLE Circular Pitch TOOTH PATTERN STRAIGHT TOOL MATERIAL High Speed Steel DIAMETER 1/2″ PITCH 50 WIDTH 3/16″ HOLE SIZE 3/16″ FINISH COATING Lapped Tooth Finish HARDNESS 58 to 60 RC NORMAL CIRCULAR TPI 50 SERIES EP WHEEL … Continued


70° 50TPI Spiral Knurl Pair
BRAND FORM ROLL STYLE Circular Pitch TOOTH PATTERN Right & Left Hand Pair TOOL MATERIAL High Speed Steel DIAMETER 1/2″ PITCH 50 WIDTH 3/16″ HOLE SIZE 3/16″ FINISH COATING Lapped Tooth Finish HARDNESS 58 to 60 RC NORMAL CIRCULAR TPI … Continued


Knurling Tool Holder
Sherline's knurling tool adds a professional touch to your parts by embossing knurls into the surface, rather than cutting them. Straight knurls are commonly used on the ends of shafts that will be pressed into other parts, while both straight and diamond knurl patterns are ideal for enhancing grip on handwheels and thumbscrews.
This tool can accommodate diameters up to 1" (25 mm) and features both right and left sides that evenly clamp down on your part as it's turned in the lathe, creating a consistent knurled pattern. It comes with one set of spiral knurls that form a diamond pattern.
Additional sizes of knurls for both diamond and straight patterns are also available in the addition knurls tab below.
Note: This knurling tool is not intended for use with riser blocks.


70° 50TPI Left Hand Spiral Knurl
BRAND FORM ROLL STYLE Circular Pitch TOOTH PATTERN Left Hand TOOL MATERIAL High Speed Steel DIAMETER 1/2″ PITCH 50 WIDTH 3/16″ HOLE SIZE 3/16″ FINISH COATING Lapped Tooth Finish HARDNESS 58 to 60 RC NORMAL CIRCULAR TPI 50 WHEEL DIAMETER … Continued