| BRAND | FORM ROLL |
| STYLE | Circular Pitch |
| TOOTH PATTERN | STRAIGHT |
| TOOL MATERIAL | High Speed Steel |
| DIAMETER | 1/2″ |
| PITCH | 30 |
| WIDTH | 3/16″ |
| HOLE SIZE | 3/16″ |
| FINISH COATING | Lapped Tooth Finish |
| HARDNESS | 58 to 60 RC |
| NORMAL CIRCULAR TPI | 30 |
| SERIES | EP |
| WHEEL DIAMETER | 3/16″ |
Back to Straight Knurls
90° 30TPI Straight Knurl Pair
Pay within 30 days interest-free with Affirm. Check your purchasing power
Related products
90° 30TPI Right Hand Spiral Knurl
BRAND FORM ROLL STYLE Circular Pitch TOOTH PATTERN Right Hand TOOL MATERIAL High Speed Steel DIAMETER 1/2″ PITCH 30 WIDTH 3/16″ HOLE SIZE 3/16″ FINISH COATING Lapped Tooth Finish HARDNESS 58 to 60 RC NORMAL CIRCULAR TPI 30 WHEEL DIAMETER 3/16″ … Continued
90° 30TPI Straight Knurl
BRAND FORM ROLL STYLE Circular Pitch TOOTH PATTERN STRAIGHT TOOL MATERIAL High Speed Steel DIAMETER 1/2″ PITCH 30 WIDTH 3/16″ HOLE SIZE 3/16″ FINISH COATING Lapped Tooth Finish HARDNESS 58 to 60 RC NORMAL CIRCULAR TPI 30 SERIES EP WHEEL … Continued
90° 30TPI Spiral Knurl Pair
BRAND FORM ROLL STYLE Circular Pitch TOOTH PATTERN Right & Left Hand Pair TOOL MATERIAL High Speed Steel DIAMETER 1/2″ PITCH 30 WIDTH 3/16″ HOLE SIZE 3/16″ FINISH COATING Lapped Tooth Finish HARDNESS 58 to 60 RC NORMAL CIRCULAR TPI … Continued
Knurling Tool Holder
Sherline's knurling tool adds a professional touch to your parts by embossing knurls into the surface, rather than cutting them. Straight knurls are commonly used on the ends of shafts that will be pressed into other parts, while both straight and diamond knurl patterns are ideal for enhancing grip on handwheels and thumbscrews.
This tool can accommodate diameters up to 1" (25 mm) and features both right and left sides that evenly clamp down on your part as it's turned in the lathe, creating a consistent knurled pattern. It comes with one set of spiral knurls that form a diamond pattern.
Additional sizes of knurls for both diamond and straight patterns are also available in the addition knurls tab below.
Note: This knurling tool is not intended for use with riser blocks.