Tip 74-Chuck Adapter Improvement for Clock and Watch Makers

-A. Bousquet

 

 

As a user of Sherline products, I found a tip to improve my chuck adapter. 

I drilled a hole ( 7/16î X 7/16î ) in the 8 mm chuck adapter to have enough space for the lantern pinion.

Later, I will drill a .125" hole end to end through this adapter for machining a long, small rod.

-A. Bousquet

Return to the TIPS page


Copyright 2015, Sherline Products Inc. All rights reserved.
No part of this web site, including the text, photos or illustrations, may be reproduced or transmitted in any other form or by any means (electronic, photocopying, recording or otherwise) for commercial use without the prior written permission of Sherline Products Inc.