P/N 67127
Sherline offers stepper motors with your choice of a pre-wired connector plug (P/N 67127, left) for use with our individual axis or CNC system drivers or with six raw wire leads (P/N 67130, right) for general use. Flats are ground onto the shafts to accommodate the coupler and handwheel set screws.
Sherline CNC systems make use of the NEMA 23 frame size stepper motor and plug shown above. The motors are also available without the plug if you are planning to use a CNC-ready Sherline machine with a driver system by another manufacturer. The strong 135 oz-in (9.7 kg-cm) steppers are equipped with a dual shaft, so a handwheel can be attached to the rear shaft to maintain manual control when the power is off.
Pre-wired, labeled 5-pin plugs on each axis make it easy to attach stepper motors to the drivers. (Click on photos for larger images.)
Pre-wired plugs for quick installation...
Both the complete CNC system and the P/N 8760 driver box come with 4 cables pre-wired with a 5-pin plug. These match the plugs on the P/N 67127 stepper motors sold by Sherline. To hook up the system all you do is plug each stepper motor into the cable for the proper axis. It couldn't get much easier than that.
CLICK HERE for complete technical specifications on the stepper motors.
RETURN TO SHERLINE'S HOME PAGE
| Home
Page | About
Sherline | Frequently
Asked Questions | Testimonials
| Lathes
|
| Mills
| Accessories
| Dealers
| Tool
Prices | Accessory
Prices |
| Contest
| Full
Size Tools | SHERLINE
Weight Scales | Race
Car Alignment System |
| IMMA
| Resources
| SHERLINE
People |