This is the replacement carbide insert for the P/N 7610 55° Negative Rake Insert Holder. Though not inexpensive, when you consider you are getting four cutting tools in one and are saving a lot of time in tool sharpening, it is really a pretty good deal.

Carbide cutters give good finishes on hard-to-machine materials such as cold rolled steel. They will also work on aluminum, brass or leaded steels, and will last practically forever; however, the best finishes on those materials are still achieved with a good, sharp high-speed steel tool.

NOTE: Replacement carbide inserts for other inserted tip tools are available through Sherline. See our page on carbide tools.

See also Sherline's 35° RH and LH inserted tip tool holders, P/N 2258.
 

READ INSTRUCTIONS FOR USING THE 55° NEGATIVE RAKE INSERT HOLDER
 

.html version

.pdf version (Requires Adobe Reader to view)