Rocker Tool Post, P/N 3057

(Click on photo for larger image.)

P/N NAME WT. PRICE
3057 Rocker Tool Post .5 lb. $30.00

About the Rocker Tool Post...

The cutting edge of a lathe tool should be set right on or just slightly below the centerline of the part being machined. With new lathe tools this is not a problem, because Sherline tool posts are made to hold them at the correct height. Older tools that have been sharpened numerous times may require shimming to bring them up to the correct height. The Sherline rocker tool post is designed to eliminate the need for shimming. The height of the cutting edge can be changed by simply adjusting the two clamping screws. This inexpensive accessory reduces setup time and also extends the life and the usefulness of your old lathe tools.

For more on other standard and optional tool posts CLICK HERE.

 

READ INSTRUCTIONS FOR USING THE ROCKER TOOL POST:

.html Version only (Web site version)


RETURN TO ACCESSORIES MASTER LIST

Shop for Sherline LATHES

Shop for Sherline MILLING MACHINES

Shop for Sherline CHUCKS

RETURN TO SHERLINE'S HOME PAGE


| Home Page | About Sherline | Frequently Asked Questions | Testimonials | Lathes |
| Mills | Accessories | Dealers | Tool Prices | Accessory Prices |
| Contest | Full Size Tools | SHERLINE Weight Scales | Race Car Alignment System |
| IMMA | Resources | SHERLINE People |

Copyright 2000, Sherline Products Inc. All rights reserved.
No part of this web site, including the text, photos or illustrations, may be reproduced or transmitted in any other form or by any means (electronic, photocopying, recording or otherwise) for commercial use without the prior written permission of Sherline Products Inc.